Placa roof

The pieces sold in this article are the Tiled Plates type board, roof arab tile plate and glazing roofs or channels. 

The plate roofs are sold per unit.

The edges or channels are sold in packs of 5 units.

These roofs have some flexibility, so it will allow you to adapt them to different shapes. They can be easily cut with scissors and it is recommended to glue with super Glue 3 or with Imedia glue. They are perfect to make roofs with the most complicated or non-existent shapes currently.

The edges or channels are perfect to unite the roofs. Singing them at the top, the roofs will be very well finished.

Measurements roof board type board: 222,30 mm x 185.25 mm x 1.2 mm (long x width x height). 18 x 15 points.

Measurements tiled Arab tile plate: 199,20 mm x 199,20 mm x 3 mm (long x width x height). 16 x 16 points. 

Arist or slate channel measures: 222,30 mm x 4 mm x 1.50 mm (largo x width x height). 18 points long. 

Available in several colors. Printed with the same coloring as the roofs in plastic injection.

Parts in 3D printing offer you endless possibilities at the time of realism without equal to your constructions. You can build the monument of your dreams or a very realistic replica of a royal monument, whether it be a castle, fortress, church, cathedral, monastery or building in general.

Being printed with 3D technology, it can have small swabs as well as a lace somewhat stronger than parts with plastic injection technology. The pieces are checked before sending to ensure a good lace and finish. The printing by layer is 0.2 mm. Made of PLA material (base Yuca), organic material, with good resistance and relative flexibility

They are 100% COMPATIBLE with the parts ancient of the 60s and subsequent EXIN CASTILL. 

They're not any pieces, they're NG Castles, quality and design is guaranteed.