Circular roof under

The pieces sold in this article are the Low circular roof.

The roofs will be found in 4 colors, 4 sizes and whole or half.

The sizes:

All the roofs (except the 3-points) have cantilever.

Tower of 3 points of diameter. There's no fly.

Tower of 5 dots of diameter with no voladizo.

5-point tower diameter with voladizo. This means that the total size of the roof is 7 points in diameter. You can also put the tower of the Great Almena of 7 points in diameter. In this case the roof will be left unflinching.

Tower of 7 points of diameter with voladizo. This means that the total size of the roof is 9 points in diameter.

Tower of 11 points of diameter with voladizo. This means that the total size of the roof is 13 points in diameter.

Available in several colors. Printed with the same coloring that the roofs in plastic injection.

Parts in 3D printing offer you endless possibilities at the time of realism without equal to your constructions. You can build the monument of your dreams or a very realistic replica of a royal monument, whether it be a castle, fortress, church, cathedral, monastery or building in general.

Being printed with 3D technology, it can have small swabs as well as a lace somewhat stronger than parts with plastic injection technology. The pieces are checked before sending to ensure a good lace and finish. The printing by layer is 0.2 mm. Made of PLA material (base Yuca), organic material, with good resistance and relative flexibility

They are 100% COMPATIBLE with the parts ancient of the 60s and subsequent EXIN CASTILL. 

They're not any pieces, they're NG Castles, quality and design is guaranteed.